AEM V2 Water Methanol Injection Kit (No Tank) Mitsubishi - SAE9254V Spring Steel Racing

- SAE9254V Spring Steel Racing Springs

The stock rear end on the WRX & STI can suffer from excessive play and slop as well as the notorious the 1-2 upshift "clunk" due to soft rubber OE bushings

Note: This BOV is for the N54 engine only

The rim well of the over 300 to 350 degree centigrade hot wheel blank is kept in a continuous rotational motion under high pressure and at high temperatures

AEM V2 Water Methanol Injection Kit (No Tank) Mitsubishi - SAE9254V Spring Steel RacingThe AEM V2 Water Injection kits are a perfect way to reduce air inlet temps and increase charge density in boosted vehicles. These AEM kits allow the user to safely run higher boost pressures and suppress detonation allowing the utilization of more timing and boost. AEM's progressively controlled high pressure pump draws water (or up to a 50% alcohol mixture) from the supplied tank (with integral fluid level sensor) to provide boost dependent variable