MiniPro Voltage/Current Sensor Off Road Stand This is a device to

This is a device to measure the strength of your 540 motors spec rotors

you will need to supply your own power leads

Unit must return to below 40° Celsius before starting a new cycle

24" 1s/2s balance charge lead featuring 5mm bullet connectors and a 2mm balance bullet on the battery side

MiniPro Voltage/Current Sensor Off Road Stand This is a device toThis is a redesign of the MiniPro 200A Current Voltage sensor. This sensor runs off a separate power supply than the power source you are using for the MiniPro. Operates off of 7. 5 15VDC, you will need to supply your own power leads. Solder the positive lead to the VIN+ and the ground to the VIN . Run the sensor in series with your power source for your motor to get the current and voltage information. Calibration of the sensor is done in the MiniPro