MOOSE RACING Water Pump Rebuild Kit 821328MSE Taillight and License Plate Holder with Turn Signal Merged the 1-7/8" head pipes

Merged the 1-7/8" head pipes into a large 2-1/4" collector that steps up to a 2-1/2" perforated core Core wrapped in stainless steel screen then encloded in fiberglass pillow Collector covered by large one-piece heat shield that is held in place with two clamps and stamped Cobra logo 4" muffler body capped with a 4" machined aluminum dual-cut tip that features small alluvial flutes Body arrives pre-set in slight upward position Works wtih stock or extended bags

Delivers a deep sonic thump that keeps that powerful V-Twin rhythm going for miles and miles

K&N® High-Flow Air Filter™ designed to increase performance

New Silencer Design Featuring: Carbon Sleeve with Carbon Fiber End Cap and stainless steel exhaust tubing

MOOSE RACING Water Pump Rebuild Kit 821328MSE Taillight and License Plate Holder with Turn Signal Merged the 1-7/8" head pipesInclude every gasket, O ring, bearing and seal required to rebuild a water pump Typical kit includes the following: bearings where applicable; rubber seals; mechanical water pump seal where applicable; side cover gasket; water pump gasket; snap rings located on water pump shaft and copper drain washers